Daily maintenance of wire strippers

Wire strippers are one of the commonly used tools for instrumentation circuit repair, motor repair, and internal circuit repair. The wire stripper is mainly composed of a knife edge, a crimping port, and a pliers handle. The pliers handle is covered with an insulating sleeve that can withstand a voltage of 500V. When the handle of the wire stripper is held tightly to make it work, it is compressed so that the tightening mechanism is tightened. At this time, the structure will not move due to the action. When the tightening mechanism fully clamps the wire, the force received by the torsion spring gradually changes to roughly deform the torsion spring, so that the shearing mechanism starts to work. At this time, the force received by the torsion spring is not enough to separate the clamping mechanism from the cutting mechanism, and the cutting mechanism is clamped after the wire sheath is completely cut. At this time, the force received by the torsion spring increases. When the force received by the second torsion spring reaches a certain level, the torsion spring begins to deform, and the clamping mechanism is separated from the shearing mechanism, so that the cut insulation of the wire is separated from the wire. To achieve the purpose of stripping. Wire strippers are mainly used to strip the insulation of various insulated wires and cable core wires.

HOT SALE WIRE-STRIPPER PLIERS KBX-65 GERMAN STYLE ADJUSTABLE WIRE STRIPPER MANUAL AUTOMATIC CABLE STRIPPER

1.Clean the rusty area on the knife edge with rust remover, and put some lubricating oil on the shaft to ensure that the pliers can be used normally. If there is damage or other problems, carry out corresponding repairs.

2.Please remove the iron filings wound on the clamp body in time to ensure smooth chip evacuation.